Eurotech ConventionalManual Call Point-EN54-11 Approved


Eurotech's resettable manual call point with unique and innovative features. It has been designed to obtain maximum visibility, high reliability in operation and pleasant aesthetical appearance and is fully approved to EN54-11.

Six modes of operation are achievable simply by choosing the appropriate internal connection terminals. All these configurations are easily accessed via the screw terminals. The internal printed circuit board is fully enclosed and protected and incorporates a current limiter that maintains a steady supply to the LED.

The unit is easily reset using the special key provided that allows a simple twist action to restore the call point to its normal operating condition. The same key is used to access the electrical connection.

Thedevice is supplied in a choice of either flush or surface mount options. Once fitted the front operating element simply snaps into place and is released using the dedicated test and removal tool supplied with each unit.

There is the provision of two cable entry knockouts on the rear plus 2 x 3 pre-marked location points on both top and bottom sides of the surface mount back box.

Technical Information
Part No 100-1017 100-1018
Mounting Surface Mount Flush Mount
Maximum Voltage: 30 Volt
Minimum Voltage* : 4.5 Volt if LED with R1 is chosen
6.0 Volt if LED with R2 is chosen
Current Rating (non-operated): 0 mA
Current Rating (operated):
Resister Values
R1 470Ω
R2 680Ω
18 mA @12 Volt - R1
13 mA @12 Volt - R2
45 mA @24 Volt - R1
31 mA @24 Volt - R2
Cable Termination: 0.5 - 2.5 mm²
Operating Temperature: -30 / +70 °C
Humidity: 0 - 95 %
IP rating: 42
Material: ABS / P glass fibre
*Below minimum voltage led current is lower than 7 mA

We are happy to serve you @ 24/7

+974 3135 9025